14
User's Manual |
CS631
Chapter 2
HARDWARE INSTALLATION
X
Jumper Settings
Clear CMOS
JP5
If any anomaly of the followings is encountered —
a) CMOS data is corrupted;
b) you forgot the supervisor or user password;
c) failure to start the system due to BIOS mis-configuration
— it is suggested that the system be reconfigured with default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system and unplug the power cord.
2. Put a jumper cap on JP9’s pin 2 and pin 3. Wait for a few seconds and set JP9 back to
its default setting, i.e. jumper cap on pin 1 and pin 2.
3. Plug the power cord and power-on the system.
JP1, JP2, and JP3 are used to configure the COM 1 port to RS232, RS422 (Full Duplex) or
RS485. The three jumpers must all be configured to the same serial mode.
2-3 On: Clear CMOS
COM 1
1-2 On: Normal (default)
1-3, 4-6 On
1-3, 2-4 On
3-5, 4-6 On
3-5, 4-6 On
3-5, 2-4 On
3-5, 4-6 On
1
1
3
3
2
2
JP1
JP2
JP3
COM 1 Serial Mode
6
4
2
5
3
1
6
4
2
5
3
1
6
4
2
5
3
1
6
4
2
5
3
1
6
4
2
5
3
1
6
4
2
5
3
1
JP3
RS232 (default)
RS422
RS485
JP1 & JP2
2
6
1
5
2
6
1
5
2
6
1
5
