46
Auto
0-4
The BIOS will automatically set the system according to your
hard disk drive’s timing.
You can select a mode that matches your hard disk drive’s
timing. Caution: Do not use the wrong setting or you will
have drive errors.
IDE Primary Master/Slave PIO and IDE Secondary Master/Slave
PIO
Your system supports five modes, 0 (default) to 4, which primarily differ
in timing. When Auto is selected, the BIOS will select the best available
mode after checking your hard drive.
Onboard FDD Controller
Enables the onboard floppy disk controller.
Disables the onboard floppy disk controller.
Enabled
Disabled
Onboard UART 1 and Onboard UART 2
Selects an address for the onboard serial port 1 and serial
port 2.
Disables the onboard serial port 1 and/or serial port 2.
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Onboard UART 2 Mode
The C586HX system board supports IrDA function for wireless connec-
tivity between your computer and peripheral devices. To use the IrDA
function, follow the steps below.
1. Connect your IrDA cable to connector J9 of the C586HX system
board. Refer to page 12 for the location of connector J9.
2. Set “Onboard UART 2 Mode” to the type of IrDA standard sup-
ported by your IrDA peripheral/device.
