25
Connecting the Parallel Printer Port
Attach the DB-25 printer port cable to connector J5 on the C586HX system
board. Make sure the colored stripe on the ribbon cable aligns with pin 1 of
connector J5. Use a small nutdriver to mount the cable into a DB-25 cutout
in the system chassis. If your printer port cable is attached to a card-edge
bracket, connect the cable to connector J5 on the system board and
mount the card-edge bracket to the system chassis.
Floppy Disk Drive Controller
The C586HX system board has a built-in floppy disk controller that sup-
ports two standard floppy disk drives. You can install any 360KB,
720KB, 1.2MB, 1.44MB, or 2.88MB floppy disk drives.
Connecting the Floppy Disk Cable
1. Install the 34-pin header connector into the floppy disk connector
(J4) on the system board. The colored edge of the ribbon should be
aligned with pin 1 of connector J4.
2. Install the other 34-pin header connector(s) into the disk drive(s).
Align the colored edge of the daisy chained ribbon cable with pin 1
of the drive edge connector(s). The end-most connector should be
attached to the drive you want to designate as Drive A.
Parallel Port
The C586HX system board has a standard connector for interfacing
your PC to a parallel printer. The parallel port on your system board can
be set to any of the following system I/O addresses:
I/O Address
3BC-3BE Hex
378-37A Hex (default)
278-27A Hex
