32
2
Hardware Installation
2.5.5 Universal Serial Bus Ports
USB 4
USB 3
Four onboard USB 2.0/1.1 por ts (Black) are at locations CN7
(USB 1-2) and CN8 (USB 3-4) of the system board.
J8 (USB 5-6) and J10 (USB 7-8) connectors allow you to con-
nect 4 additional USB 2.0/1.1 por ts. The USB por ts may be
mounted on a card-edge bracket. Install the card-edge bracket to
the system chassis then inser t the connector that is attached to
the USB por t cables to J8 or J10.
BIOS Setting
Configure the onboard USB in the Integrated Peripherals
submenu (“Onboard Device” section) of the BIOS.
If you are using a USB 2.0 device, you must enable the USB 2.0
function in the same submenu mentioned above. Refer to chap-
ter 3 for more information.
Driver Installation
You may need to install the proper drivers in your operating
system to use the USB device. Refer to your operating system’s
manual or documentation for more information.
W
USB 5-6
USB 7-8
W
USB 2
USB 1
1
VCC
-Data
+Data
Ground
Key
VCC
-Data
+Data
Ground
N.
C
.
2
10
9
X
