DFI 586ITXD, User Manual

Page: 26 / 90

2
26
586ITXD System Board User’s Manual
store all information about your current
operating session onto your hard drive and
enter the “Soft-Off” (Soft Power Off) state.
The operating session where you left off
before the system enters the “Soft-Off”
state will resume, just as it was, when one
of the following event occurs:
• The system powers on at the set date
and time in the “Resume By Alarm” field.
• Modem ring-on occurs.
• When you press the Power button.
Refer to Appendix E for more information.
Note:
If you are not using the “Suspend to Disk” function, set this field
to “PowerON Suspend”.
Throttle Duty Cycle
The duty cycle indicates the percent of time the STOPCLK# signal is
asserted. This field is used to select the percent of time the CPU will
be inactive when the system enters the Doze, Standby or Suspend
mode. The higher the percent selected, the greater the percentage of
time the CPU is inactive, therefore, the more it saves power.
Options 12.5%, 25.0%, 37.5%, 50.0%, 75.0%, and 87.5%
Default 62.5%
Note:
If the percent selected in this field is too high, your system may
not be able to enter the Doze, Standby or Suspend mode. If this
occurs, select a lower percent to allow the system to enter the
power saving mode.
VGA Active Monitor
Enabled VGA activities will cause the system to wake up from
power saving mode.
Disabled VGA activities will not cause the system to wake up from
power saving mode.