DFI 586ITXD, User Manual

Page: 66 / 90

B
67
Connecting Cables
Adding a Second IDE Hard Drive
When using two IDE drives, one must be set as the master and the
other as the slave. Follow the instructions provided by the drive
manufacturer for setting the jumpers and/or switches on the drives.
We recommend that you use Enhanced IDE or ATA-2 and ATA-3
hard drives be from the same manufacturer. In a few cases, drives
from two different manufacturers will not function properly when
used together. The problem lies in the hard drives, not the system
board.
Important:
If you encountered problems while using an ATAPI CD-ROM
drive that is set in Master mode, please set the CD-ROM drive
to Slave mode. Some ATAPI CD-ROMs may not be recognized
and cannot be used if incorrectly set in Master mode.
Preparing an IDE Drive for Use
IDE disk drives are already low-level formatted, with any bad-track
errors entered, when shipped by the drive manufacturer. Do not
attempt to do a low-level format or you may cause serious damage
to the drive.
To use an IDE drive, you need to enter the drive type (this
information is provided by the drive manufacturer) into the system’s
CMOS setup table. Then run FDISK and FORMAT provided with
your operating system. You may also use the “IDE HDD Auto
Detection” function which will allow the BIOS to auto detect your
hard drive type. Refer to the Chapter 2 - IDE HDD Auto Detection
section for details.
Warning:
Do not run FDISK and FORMAT programs on a drive that has
already been formatted or you will lose all programs and data
stored on the drive.