26
With a modem being installed, you can remotely transmit or access
data without physically going to your system. To “wake up” your sys-
tem, follow the steps below.
1. If your ATX power supply has an On/Off switch, set this to On so
that even when you have shut down your system, it will always
remain in “standby” mode. Note that when you need to use this
function, you have to shut down your system by the icons under
Windows 95.
2. Enable Power Management. This will allow your system to enter
Suspend mode after you have finished accessing data. Refer to the
Power Management Setup section for more information.
3. Set Jumper JP26 accordingly. This will depend on the COM port
where your modem is connected.
Important:
Before connecting your cable to COM1 or COM2 (depending on your
setting), you must turn on the power of modem first to avoid your ATX
power supply being interfered.
Factory Testing Jumpers
The jumpers below are for factory
testing only and should always
be set to their default configura-
tion. Reconfiguring these jumpers
will cause problems with your
system board.
JP14:
5-6 On, 7-8 On
JP30:
All Off
