8514-302-001 REV B page 8
MOUNTING HEIGHT
A concrete pedestal or steel-mounting base that elevates the machine
above the floor level is suggested to provide easy access to the loading
door.
Suggested Amount to Elevate Washer:
T-300/350/350SWD: approximately 8 inches (203 mm)
Contact a Dexter laundry equipment distributor for recommended steel
mounting bases. Available steel mounting bases:
Washer
Part Number
Height
T-300
9945-094-003
8” (203 mm) Single Base
T-300
9945-094-004
8” (203 mm) Double Base
T-350
9945-121-001
8” (203 mm) Single Base
T-350 SWD 9945-151-001
6” (152 mm) Single Base
If an elevated concrete pedestal is desired, it should be embedded and
tied into the existing floor. DO NOT install a pad on top of the existing
floor. Cut through existing floor as shown below. See Machine Mounting
Detail Figures for floor thickness and bolt sizes.
EXPANSION ANCHORS ARE NOT RECOMMENDED FOR USE IN CONCRETE
PEDESTALS BECAUSE THE ANCHORS ARE TOO CLOSE TO AN EDGE,
CAUSING IT TO BREAK OUT.
FOUNDATION AND PAD OPTIONS
All installations require reinforced concrete floors. Refer to appropriate
model Machine Mounting Detail Figures 1-1, 1-2 and 1-3 for minimum
floor thickness and minimum pad sizes. See mounting diagram for overall
washer dimensions.
Refer to appropriate model Figure 1-4 for side by side mounting
dimensions.
WASHER INSTALLATION ON EXISTING FLOOR:
Summary of Contents for T-300 VENDED
