Dexter Laundry 20VCIS2, Manual

Page: 372 / 387

FR
IT
EL
PL
ES
PT
RU
UA
BR
EN
RO
KZ
FR
IT
EL
PL
ES
PT
RU
UA
RO
KZ
EN
BR
371
7. TROUBLE SHOOTING
Problems Probable causes Corrective action
Device doesn’t
start.
The battery is less
power.
Check the battery and charge it.
The charger is
broken.
Repair by customer care.
On/off switch may
be defective.
Engine faulty.
Device operates
sporadically or
at low power.
The battery is less
power.
Check the battery and charge it.
Worn or cracked
Carbon Brushes. Check Carbon Brushes.
Replace if damaged or worn.
Wood burns at
ends when cut.
Dirty Blade.
Clean Blade using blade cleaner or mineral spirits.
Material is
binding.
Check position of work material on Table. Material must
be flat, flush against
Fence and supported on ends.
Material frays or
chips out.
Finished side is
down. Keep finished side of material up or facing operator.
Bottom and back side are prone to chip out.
Blade chipped or
dull. Check for damaged teeth.
Sharpen or replace blade.
Blade
inappropriate
for material.
Check blade manufacturer’s recommendations for
material being cut. For cross cutting hard wood and
for precision cuts use a thin kerf blade with 60 or more
teeth.
Material is
unsupported.
Use a thin piece of scrap material, such as 1/4" plywood,
underneath or behind the material to support the edges
of the material as it is being cut.