Dewert User Manual DX1 Series– Updated 05.2021/1 MDR Page 8 of 16
steel gripping disc at the end. To insert the holding bar, feed the guide cotter pin of the stainless steel bar into the
rear hole of the angle mount bracket/retaining bracket. Then push the sleeve with the gripping disc against the
spring force and feed the front guide cotter pin into the second hole. Then relieve the spring tension on the sleeve.
To release the paper roll holder, proceed in the same way.
Side guard (optional):
Laterally lowerable side guard (standard equipment for models 1090/H, 1093/H and 1095/H)
Operating the side guard:
Hold the centre of the rail of the side guard with one hand and release it by moving it minimally sideways
(either towards the head or foot part). At the same time, use your other hand to pull out and turn the locking
pin (red knob) located in the centre of the side guard underneath the upholstery frame. Press down or pull up
the side guard using the rail until the locking pin engages audibly. After the locking pin has engaged, the side
guard is secured in place. To check whether the side guard has engaged properly, move it sideways on the
rail (either towards the head or foot part). Only limited movement should then be noticeable.
Always operate the side guard with the necessary caution. Never operate the side guard if the hands,
fingers, etc. of another person are located between the bars or on the mechanism of the side guard.
Risk of being crushed/pinched!!!
The laterally lowerable side guard is completely screwed in place. If the side guard becomes too loose or has
excessive lateral play over time due to use, it can be readjusted by tightening the screws. The moving parts of
the side guard should be re-lubricated slightly at regular intervals (spray oil, e.g. Ballistol).
Side guard, lowerable, for side rail
This side guard can be placed and fixed on any side rail using a clamp. By loosening the toggle screw of the
clamp, the position and height of the inserted side guard can be shifted and adjusted respectively.
Complete lowering below the upholstery level can only be achieved if the guide points in the direction of the
upholstery when the side guard is inserted into the clamp.
Please note:
Never use the side guard as a push handle. It has not been designed for this purpose.
3. Additional accessories (for user-specific table configuration, model dependent)
•
Upholstery width 800 mm
•
Twin castors
∅
100 mm, centrally lockable, non-conductive
•
Twin castors
∅
100 mm, individually lockable
•
Wheel-lifting/fixing mechanism
•
3-sectioned head part
•
Side guard
•
Paper roll holder
•
Additional foot switch or hand switch
•
Foot switch fixation on the underframe
•
Foot switch rails, for operating the height, laterally or surround
