ENGLISH
11
Prior to Operation
t *OTUBMMUIFHVBSEBOEBQQSPQSJBUFEJTDPSXIFFM
Do not use excessively worn discs or wheels.
t #FTVSFUIFJOOFSBOEPVUFSGMBOHFTBSF
mounted correctly.
t .BLFTVSFUIFEJTDPSXIFFMSPUBUFTJOUIF
direction of the arrows on the accessory and
the tool.
OPERATION
Instructions for Use
WARNING:
Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
Before
reconnecting the tool, depress and
release the trigger switch to ensure that
the tool is off.
WARNING:
t&OTVSFBMMNBUFSJBMTUPCFHSPVOEPS
cut are secured in place.
t4FDVSFBOETVQQPSUUIFXPSLQJFDF
Use clamps or a vice to hold and
support the workpiece to a stable
platform. It is important to clamp and
support the workpiece securely to
prevent movement of the workpiece
and loss of control. Movement of
the workpiece or loss of control may
create a hazard and cause personal
injury.
t"QQMZPOMZBHFOUMFQSFTTVSFUPUIF
tool. Do not exert side pressure on the
disc.
t"WPJEPWFSMPBEJOH4IPVMEUIFUPPM
become hot, let it run a few minutes
under no load condition.
Proper Hand Position (fig. 6)
WARNING:
To reduce the risk of
serious personal injury,
ALWAYS
use
proper hand position as shown.
WARNING:
To reduce the risk of
serious personal injury,
ALWAYS
hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the side
handle (figure 1), with the other hand on the body of
the tool, as shown in figure 6.
Switches
CAUTION:
Hold the body of the tool
firmly to maintain control of the tool at
start up and during use and until the
wheel or accessory stops rotating. Make
sure the wheel has come to a complete
stop be fore laying the tool down.
NOTE:
To reduce unexpected tool movement,
do not switch the tool on or off while under load
conditions. Allow the grinder to run up to full speed
before touching the work surface. Lift the tool from
the surface before turning the tool off. Allow the tool
to stop rotating before putting it down.
SLIDER SWITCH DWE8200S & DWE8210S (FIG. 3)
WARNING:
Before connecting the tool
to a power supply, be sure the slider
switch is in the off position by pressing
the rear part of the switch and releasing.
Ensure the slider switch is in the off
position as described above after any
interruption in power supply to the tool,
such as the activation of a ground fault
interrupter, throwing of a circuit breaker,
accidental unplugging, or power failure.
If the slider switch is locked on when the
power is connected, the tool will start
unexpectedly.
To start the tool, slide the slider switch (g) toward the
front of the tool. To stop the tool, release the slider
switch.
For continuous operation, slide the switch toward
the front of the tool and press the forward part of
the switch inward. To stop the tool while operating
100mm Sanding Flap Discs
backing flange
non-hubbed sanding
flap disc
clamp nut
Type 27 guard
