DeWalt DS200, Instruction Manual

Page: 30 / 104

English
23
Default E-mail/
Text Msg Notice Meaning Action Required
Sitelock Event: Auto periodic This is a weekly test None. This is a notification
test, Sensor # 000 performed between the that the system is operating
DS100 and Sitelock to properly.
assure that the unit and
system are working properly.
Sensor 000 is the Base Unit.
Sitelock Event: Manual User has performed a None. This is a notification
test, Sensor # 080 cell radio test. Sensor that the system is operating
or # 000 # 080 or # 000 indicates properly.
that this is a manual test.
Sitelock Event: Low system The Base Unit battery If AC power is not applied,
battery, Sensor # 000 voltage is too low. After plug in the unit. If AC power
1 hour, the unit will is applied, the battery is failing
become disarmed and go and needs to be replaced
into standby mode. at a D
E
WALT authorized
service center.
Sitelock Event: Burglary Unit is armed and an Contact the police and
alarm open, Sensor # 000 unauthorized intruder has provide the appropriate
been detected by the information to notify them
Base Unit motion or of an intrusion.
vibration sensor.
Sitelock Event: Burglary Unit is armed and an Contact the police and
alarm open, Sensor # XXX unauthorized intruder has provide the appropriate
been detected by sensor XXX. information to notify them
of an intrusion.
KEY # of presses
PAD 1 2 3 4 5
1 1 1 1 1 1
2 2 A B C 2
3 3 D E F 3
4 4 G H I 4
5 5 J K L 5
6 6 M N O 6
7 7 P Q R S
8 8 T U V 8
9 9 W X Y Z
0 0 space . space .
ALPHA/NUMERIC CHART
Display Event
Unsecured device x txt Unsecured
Tampered device x txt Tamper
Unsecured base motion Internal PIR trip
Unsecured base vibration Internal vibration trip
System alarm Start of alarm cycle (8 min.)
ALARM CODES
CELL PHONE TEXT MESSAGE CODES
NOTE: The subject line of the E-mail/ Text Message identifies the name of the Base Unit either
alarming or under test.