8
ASSEMBLY & INSTALLATION
Install The Counter Weight and Foorplate
WARNING
This front-weight kit is required when operating any compatible zero-turn
tractor models equipped with a grass collector. Failure to install this kit
may result in serious injury or death.
WARNING
Before beginning installation, place the zero-turn tractor on a firm and
level surface, set the parking brake, place the PTO in the disengaged
(OFF) position, stop the motor and remove the ignition key to prevent
unintended starting.
NOTE
: The following steps require the use of a T-40 Torx drive and 1/2” socket for footplate removal
and re-installation, and a 9/16” socket and wrench for weight kit assembly and installation.
1.
To install the RZT bagger
weight, you will have to
remove the footplate.
In figure 18, remove
the screws (710-3085)
indicated by unscrewing
the 4 nuts (712-04065)
that are holding them in
place.
2.
Attach the RZT bagger
weight (719-04271A) and
three weight plates (789-
02137) to the weight
hanger brackets (Left -
789-04077, Right - 789-04078)
with two 3/8” hex head
capscrews (710-3085) and two
nus (712-04065) as shown in
Figure 19.
3.
Visually center the weight bar
assembly on the tractor and using
two 7/16” hex head capscrews
(710-3279) and two nuts (712-04065) secure the counter weight assembly
to the tractor as shown in
Figure 20.
4.
As shown in Figure 21,
place the footplate (703-
26752) onto the left and
right handle of the bracket
(703-24845) so that the
two holes on each side
align. Revearse the process
you used to remove the
footplate.
Figure 18
Figure 19
Figure 20
Figure 21
Summary of Contents for 49A70003038
Page 31: ...NOTES 31 ...
Page 32: ...NOTES 32 ...
