8
ENGLISH
Preparing espresso coffee
In case of operation directly after the procedures of pages 5 to 7, you can check the water level in
the tank and skip the operations of pages 8 and 9 (passing hot water).
Fill water into the water tank.
①
Press the “push release” (Tank open)
button to open the tank cover.
1.
①
②
Take out the water tank.
④
Set the water tank into the body.
At this time, insert the tip of the hose in the tank
securely into the water supply port of the body.
Incomplete insertion can lead to leakage of wa-
ter.
Push the tank cover to close it.
②
④
③
When removing the water tank, hold the ma-
chine down so that it will not move.
③
Fill water into the water tank.
Fill in max. 1.5 liters of water.
Do not fill water above the indicated line.
Water level in the tank
The tank has a capacity of approximately 1.5 liters. When the
water level drops and becomes low (approximately 250 to 300
cc), the word “water” of the water level warning lamp part lights.
push
release
steam
POWER
espresso
POWER
water
water
⑤
Insert the plug of the power cable
into a wall outlet.
⑤
Connect the power
cable directly to a wall
outlet. Connection to
an extension cable is
not only dangerous,
but the supplied volt-
age may not be suffi-
cient for the product to
exhibit its full perfor-
mance.
Do not fill in
water above
this line.
Tips
Tank hose
Body water
supply port
This unit is equipped with a
water softening resin filter in
the tank, and hard water is
changed to soft water, but
with use for a long time, min-
erals will be deposited in the
water passages. Continued
use in this condition will cause
trouble.
The water softening resin fil-
ter should be replaced ap-
proximately every 2 months
with normal use.
