19
ENGLISH
No power
Espresso seeps from the pod
holder
Dripping continues after extraction.
No espresso comes out.
The pump cannot be heard and
no espresso comes out.
N o s t e a m c o m e s f r o m t h e
steam nozzle.
The milk does not foam suffi-
ciently.
The extracted espresso is not
hot enough.
Water leaks from the bottom.
The body becomes hot.
Troubleshooting
If the product does not work, if espresso cannot be made, milk foaming is not possible, etc.,
please check according to the following table.
Symptom
●
The power cord is disconnected.
●
The height of the pod holder is low (the handle is loose).
→
Adjust the height of the pod holder (page 11).
●
The pod filter of the pod tray set is dirty. (Clean the filter.)
●
This is caused by dripping of coffee in the pod holder, and it is normal.
●
The water tank is empty.
●
No coffee pod has been set.
●
The internal fuse is blown.(Please contact your dealer or near service center.)
●
There is not sufficient water in the water tank.
●
The steam nozzle is clogged. (Please contact your dealer or near service center.)
●
The steam nozzle is clogged. (Please contact your dealer or near service center.)
●
There is not sufficient water in the water tank.
●
The milk is not cold enough.
●
The milk is not fresh.
●
Too many appliances are connected to the outlet. (Extraction with too low tempera-
ture may occur when the power supply voltage has dropped. Connect the product to
a wall outlet.)
●
Low-fat milk is used. (Use milk with a fat content of 3.6 % or more.)
●
Too many appliances are connected to the outlet. (Extraction with too low tempera-
ture may occur when the power supply voltage has dropped. Connect the product to
a wall outlet.)
●
Espresso should be drunk when its temperature is 65 to 80 ºC. A milk temperature of
63 to 67 ºC is suitable.
●
The water tray is full. (Empty the water tray.)
●
The body becomes hot because it radiates the heat of the internal boiler, but this is normal.
Cause
