DSE F501-300 (Rev 06/28/19)
Page 15 of 15
34.
Connect the black wire with the round eyelet to a ground located under the dash. Make sure
a proper ground is obtained by removing any rust or paint from the metal.
35.
Connect the negative battery lead and test the wiper system. Upon a successful test, the
wiper conversion is now complete. Secure the new wiring harness under the dash and in
the engine compartment. Re-install the cowl panel along with any other components that
had been removed.
NOTE:
In some cases high energy ignition systems have caused interference with the
correct operation of the Selecta-Speed Wiper Kit due to spark plug wires routed closely to
the wiper motor. If this occurs, re-routing your spark plug wires may be neccesary.
If you have any questions before or during the installation of this product please contact
Legal Disclaimer:
Detroit Speed, Inc. is not liable for personal, property, legal, or financial damages from the use or misuse of
any product we sell. The purchaser is solely responsible for the safety and performance of these products. No warranty is
expressed or implied.
