DETEWE OpenCom 510, User Manual

Page: 70 / 164

68
MS+A1-8 Modules
Operational Information
The MS+UPN2-8 interface card can
be exchanged during operation, i.e.
without powering down the system.
However, the slot must first be deac-
tivated in the
Configurator in the
web console (see Installing Interface
Cards starting on page 25).
DECT base stations can be connected
only if the interface card has been
installed in the master system of a
cascaded configuration.
MS+A1-8
Field of Application
The MS+A1-8 interface card pro-
vides eight analogue interfaces for
connecting analogue terminals.
The MS+A1-8 interface card can be
installed in any of the slots (1 to 12)
of the OpenCom 510 (see
Slots start-
ing on page 22).
Technical Information
■
The MS+A1-8 interface card can
also be installed in a slave sys-
tem.
■
The MS+A1-8 interface card
supports pulse dialling as well as
dual-tone multi-frequency
(DTMF) dialling. The central re-
ceivers of the MC+1-3 interface
card are used for DTMF recogni-
tion.
■
Calling line identification pres-
entation (CLIP) is supported.
■
The consultation feature can be
selected by means of a flash key
and/or earthing key.
■
The MS+A1-8 interface card
runs on software acquired from
the system. After the card has
been installed it will automati-
cally load the required software.
■
No settings need to be made on
the MS+A1-8 interface card.
Pin Assignment
For information on the a/b interface
pin assignment, refer to
a/b Ports
starting on page 40.
Indicators
There are four LEDs on the front of
the MS+A1-8 interface card.