3300-0329-0M Rev C
y
apex Portable Scale Owner’s
35
DISPLAY SCALE WI-FI AND BLUETOOTH SETTINGS
If your scale is the Model apex-RI-C, additional settings will be shown after the calibration and
configuration counters have been shown.
To display the Wi-Fi and Bluetooth Settings, follow the steps below:
1. With no weight on the scale, press and hold the
key for approximately 5 seconds.
2. The display will show height for a short period of time, and then change to the show the
software revision of the scale for a few seconds.
3. Release the key.
4. The display will change to show the Calibration Counter (
!
) for approximately two
seconds and then the Configuration Counter (
+
) for approximately two seconds.
5. Next, the Redbird (
92`9
) software revision for the Wi-Fi and Bluetooth (BLE) module will
be displayed.
6. If Wi-Fi is enabled (
=`)
=
#0
), the following will be shown:
a. The Wi-Fi status Connected or Disconnected (
7607;
or
3-:70
) will be displayed.
b. The four octets
1
of the static IP address for the scale will be shown.
c. The network name (
**-
) will be shown.
7. After that, the Bluetooth (BLE) advertisement data Apex Scale XX:XX:XX:XX:XX:XX will
scroll across the display. Note that the X’s represents the MAC address and that the
colons between the MAC address will not be shown.
NOTE:
The factory setting for Bluetooth (BLE) is On (
!
=
#0
). If Bluetooth (BLE) has
been disabled (
!
=
#55
), the Bluetooth (BLE) advertisement will not be displayed.
8. The display will change back to showing live weight.
9. Press the
key to return to normal operation.
1
If the Wi-Fi is Disconnected (
3-:70
), and a scan of the Wi-Fi networks shows
“REDBIRD_WIFI_XX:XX” AP, then the Wi-Fi module is in listening mode. Refer to the
Configure Wi-Fi Network Module
section for the procedure to set the Wi-Fi credentials.
