Detection Systems
Abacus User Guide
Chapter 4.33
1502 081010 Off
K3 Engnr.
1502 081010
Engineer
1502 081010
Prog Chng
1502 081000
Time Chng
1502 081010 06B
Landing Smoke
06 FIRE
1502 081010
Reset FIRE
1502 081010 05A
Bedroom Button
05 PA
1502 081010
Reset PA
1502 081010 02A
Hallway PIR
02 ExFx
1502 081010
ALARM ok!
1502 081010
ALARM TRBL
1502 081010
Reset Alarm
1502 081010
Duress
1502 081010 Off
Duress
1502 081010 User
Keypad 3 MED
The Engineer unset the installation. (The engineer is only able to unset the
installation if it was first set by the engineer. The engineer cannot unset
any part of an installation if it was set by a user code).
The installation was put into an engineer mode.
The engineer entered the engineer’s programming mode – he/she may have
changed one or more of your system parameters, or just checked that they
are correct.
The date or time was changed to the date of the 15
th
of February and/or a
time of 8:10 AM.
A smoke detector on the landing connected to zone 6 cct B has been
activated and signalled fire.
The panel was reset after generating a Fire Alarm.
A bedroom PA button has been activated connected to zone 5A and
signalled PA.
The panel was reset after generating a Personnel Attack Alarm.
The hallway PIR, on zone 2A, was activated when the panel was set and
caused an intruder alarm to be generated.
The alarm activated (see adjacent log reading for cause) triggered the
communicator and the BT lines were in working order. I.e. no line faults.
The alarm activated and the communicator was unable to signal to the
central station, or no communicator fitted.
The panel was reset after generating an Intruder Alarm.
A Duress code was entered and remote signalling took place if a
communicator was fitted.
The system was unset (On = Set) using a duress code and remote
signalling took place if a communicator was fitted.
The two ! keys on keypad 3 were pressed together and a medical alarm
was signalled to the central station if a communicator was fitted.
