Detection Systems
Abacus User Guide
Chapter 4.20
For code 1 it bypasses this option and points to code name (code 1
is always a master code).
For code 2 and above press the
NO
key until display reads the code type required. (Master, Main,
Clnr
, Area 1,Area 2,
Area 3, Duress, Holder
and On/Off
[
Clnr = cleaner])
. When the code type
required is displayed press the
YES/PART
key to accept and the > points away.
(See System Features)
Press the
YES/PART
key to accept a user’s name and repeat for next code.
To program in a user’s identification name press the
NO
key, refer to the
keystroke/character chart and press the keys required. I.e. for Bill, press the
1
key five times,
YES/PART
key, the
3
key three times,
YES/PART
key
the
4
key three times the
YES/PART
key then the
4
key three times. (To correct a error press the
YES/PART
key followed by the
NO
key) To complete press the
YES/PART
key until next code is
displayed. To make a space press the
YES/PART
key twice. (
Version 5000 or later software, Quick
escape, Press the
0/ESC
key followed by
YES/PART
key, or quick delete of fu ll name, press
0/ESC
key
followed by
NO
).
On completion of programming of the codes, press the
0/ESC
key.
For mode 2 area operation, version 5000 software or later, the following
programming is available.
This menu selects the area that the main code and duress codes will set and
unset. To select press the
NO
key until main = area numbers required, then
press the
YES/PART
key to accept. Repeat for Duress (Software version
5000 only) on pressing the
YES/PART
key the display changes to:
Press the
4
key to return to the day mode and check that the new number(s)
works and any old number(s) is/are deleted, or press the number displayed,
for function required.
Notes.
Codes can only be programmed/deleted by the master code.
One master code (code 1) is the minimum number of user codes for the system.
Code 1 is factory default as 1234; it should be changed from this number to one that only
you know, as soon as possible for the security of the installation. It is advised not to use
consecutive or numbers like 1066 that can be easily compromised.
When area’s are used, a minimum of one master code and one code for each area
used must be programmed for correct operation of the installation.
When programming codes it is recommended that names, or idents, are prgrammed for
each code, for identification of which code user operated the system.
New numbers only become active on return to the day mode.
If a number has already been programmed as a code and you attempt to program the
same number again, code conflict will be detected (erro tone sounded and code displayed
removed) and prevent that number being used, retype in a different number or press the
YES/PART key to carry on programming.
Delete a User Code
ONLY A MASTER CODE CAN DELETE A USER CODES.
Should you attempt to delete code 1, it will revert to the factory default of 1234.
From the day mode, enter the User Master code (1234).
Code 1 654321
Master >Bill
Code 2 =Spare
Master
Main
=123
Duress =123
1=Prog 2=Test
3=log4=Day(Quit
)
0712 03:46P
System Off
