v.171024
E5
ENGLISH
WaRninG!
Flammable cargo can ignite from exposure to heat.
Be aware
of the possible fire risk and property damage resulting from the vehicle’s exhaust
system pointing at or running near the cargo in the carrier. Do not use if this
condition exists.
aSSembly
SeTuP The caRRieR
Your Cargo Carrier will require some light assembly prior to use. It is important
that you read the entire manual to become familiar with the product BEFORE you
assemble and use the Cargo Carrier. Before assembling and operating the Cargo
Carrier be sure that you have all parts described in the Parts List and Assembly
Diagram located on the last pages of this manual.
1. Align the Top Carrier Frame (1) with the Carrier Frame (8). Connect them
with the two Reflector Plate with reflector (4) on the outside rear corners of
the Cargo Carrier using Bolt (9) and Nut (10) - see Assembly diagram. The
reflective side must be facing the rear of the Cargo Carrier.
2. Use the Small Connect Plate (2) to connect the Top Carrier Frame (1) to the
Carrier Frame (8): Attach each end of the Small Connect Plate (2) to the Top
Carrier Frame (1) and the Carrier Frame (8) using Bolt (9) and Nut (10) - see
Assembly diagram. Repeat for each Small Connect Plate (2).
3. Attach the Middle Connect Plate (3) so that the top and bottom of the Middle
Connect Plate (3) is attached to the Top Carrier Frame (1) with three Bolts (9)
and three Nuts (10) on each end. A Middle Connect Plate (3) is attached to both
the front and back of the Cargo Carrie. See Assembly Diagram.
4. Place the Hitch Connect Frame (15) underneath the Carrier Frame (8) and align
the holes.
5. To secure the Connect Frame (15), insert a Bolt (17) through both holes in the
Carrier Frame (8) and the Hitch Connect Frame (15). Slide on Washers (18),
and thread on Nut (19) - see Assembly Diagram.
mOunTinG caRRieR TO hiTch ReceiVeR
1. Remove the Hitch Pin (14) and the Safety Pin (16) from the front of the Hitch
Connect Frame (15).
2. Slide the Anti-Tilt Bracket (13) over the end of the Hitch Tube. Make sure the
large open end of the Anti-Tilt Bracket need to face hitch receiver on car, and
the bolts are downwards.
3. With assistance, lift the empty Carrier and slide the open end of the Hitch Tube
into the hitch receiver, and secure them with the Hitch Pin (14) and the Safety
Pin (16).
4. Slide the Anti-Tilt Bracket (13) up against the hitch receiver. Tight¬en the two
bolts against underside of hitch receiver collar, then secure the two nuts.
imPORTanT Safe OPeRaTinG PRacTiceS
