DESi Utopic Series, User Manual

Page: 6 / 12

1.2. Fingerprint Reader
First of all, unscrew the set screw at the bottom of reader with a 19 mm (3/4") hex key and
seperate metal part and plastic part. After that, remove the battery, if it is already placed. Use
one of the methods below:
1.2.1. First Method (from Inside)
1.2.1. Second Method (from Outside)
Place reader to the door
and make a sign with a pen
through hole.
Drill a hole (side to side)
from signed point with 5
mm bit.
Put the long screw with
washer to hole from inside.
Outcoming part need to
be at most 12 mms.
Place reader as in 1st step.
Tighten the short screw by
using pointed hole.
Install battery and fix the
metal cover with long
screw installed at 3rd step.
Tighten the set screw.
Install battery and place
the metal cover.
1st Step 1st Step 2nd Step 2nd Step 3rd Step 3rd Step
4th Step 4th Step 5th Step 5th Step 6th Step 6th Step
1st Step 1st Step 2nd Step 2nd Step 3rd Step 3rd Step
6
Place reader to the door
and tighten it with short
screws from two holes.
Tighten the set screw.