www.fmiproducts.com
111826-04E
17
OPERATION
Continued
REMOTE OPERATION
6. Press the buttons
and
at the same
time. A short acoustic signal confirms the
start sequence has begun.
Further short acoustic signals (0.2 sec., 1
Hz) indicate the ignition process until it is
completed and main gas flows. If pilot is
already lit, motor will turn on (max. flame
height) while buttons are pressed down.
If pilot does not light, see
Troubleshooting
,
page 22.
7. Press
to turn on main burner and
increase flame height. Press
to de-
crease flame height and shut off main
burner.
8. Short tapping of either button allows
incremental change in flame height.
9. Press OFF button to switch off main gas
and pilot gas.
FUNCTIONS OF
REMOTE CONTROL
Battery
• After the charged battery has been correctly
installed, the remote hand set is ready for
operations.
• Remove the battery if the remote handset
will not be used more than one year.
Changing The Code
The control is radio frequency operated. A
code (chosen from among 4,000 available
codes) is preset for all valves, but can be
changed if required (15 additional codes avail-
able). Change DIP switch position. (The DIP
switch is located inside the hand held control
at the top of the battery compartment.) Then
press the receiver's reset button until you
hear a second (longer) signal. When press-
ing the
button on the remote handset in
the following 20 sec., the receiver learns the
new code.
SET
OFF
STAND
BY
Figure 17 - Control Panel for Hand-Held
Remote
Battery Replacement
Remote handset battery needs to be changed
when LED is dim. Battery life expectancy is
2 to 3 years. Replacement is recommended
at the beginning of heating season. Bat-
tery needs to be changed when acoustic
error message appears during ignition (see
Identifying Error Signals from Receive
r on
page 24).
Changing Mode of Operation
• Press the SET button quickly to change the
mode of operation in the following order:
MAN,
TEMP, TEMP, TIMER.
• Manual flame height adjustment (MAN
appears on display): Press
to turn on
the fire (main burner) or to increase flame
height. Press
to decrease flame or to go
down to pilot only. The receiver acknowl-
edges the transmission with an acoustic
signal.
• The day time temperature mode (
TEMP
appears on display): The sensor in the
transmitter measures room temperature.
Setting The Time
• After connecting the battery or by si
-
multaneously pressing
and
the
display will start to flash. You are in the
set mode.
• From SET mode press
to set the
hour and
to set the minute.
• Wait or press OFF to return to the
manual mode.
Shut-off Procedure
To save battery power; press
to turn main
gas to pilot gas. Press OFF button to shut off
the device including pilot flame. The device
can be shut off with ON/OFF switch, thus
disabling the remote hand set.
Setting The Display ( °C/24h and °F /12h)
Press and hold OFF and
until display
changes from °F (and 12 hour clock) to °C
(and 24 hour clock) or vice versa.
