www.desatech.com
111035-01F
18
INSTALLATION
Continued
Figure 24 - Rear Log Placement (Variable
Manually-Controlled Models)
Figure 25 - Front Log Placement
(Variable Manually-Controlled Models)
Figure 26 -Control Cover Log Placement
(Variable Manually-Controlled Models)
INSTALLING LOGS
WARNING: Failure to posi
-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact
-
ing logs will create soot.
It is very important to install the logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
Variable Manually-Controlled Models (VSL)
1. Place rear log on 2 pins on rear brackets (see
Figure 24).
2. Place front log on grate fingers making sure
“V” notches in log fit over grate fingers (see
Figure 25).
3. Place control cover log onto two pins on front
log assuring the cover log seats into cutout
section of front log (see Figure 26).
Grate
Fingers
Remote-Ready Models (VDL)
1. Place rear/middle log over burner. Log will
fit on two pins on rear bracket (see Figure 27,
page 19).
2. Place front log on grate fingers, making
“V” notches in log fit over grate fingers (see
Figure 28, page 19).
3. Place control cover log onto two pins on front
log assuring the cover log seats into cutout
section of front log (see Figure 29, page 19).