![background image](http://html1.mh-extra.com/html/desa/tudor-cgdv32nr/tudor-cgdv32nr_owners-operation-and-installation-manual_2486215023.webp)
www.desatech.com
116646-01H
23
FIREplaCE
INSTallaTION
Continued
INSTALLING OpTIONAL WIRELESS
HAND-HELD REMOTE CONTROL
HRC100 AND HRC200 SERIES
NOTICE: Use only alkaline bat
-
teries (not included).
Installing Remote Receiver
1. Open bottom louver and locate switch
bracket on the left.
2. Unscrew switch bracket. Lean bracket
forward so you are able to access the
back of remote receiver.
3. Locate battery clip mounted on back of
receiver. Slide a 9-volt alkaline battery (not
included) through the clip (see Figure 38).
4. Attach terminal wires to battery.
5. Connect wires from receiver to TH and
TPTH to control valve (see Figure 39).
6. Replace switch bracket.
Figure 38 - Attaching Alkaline Battery to
Receiver
Figure 39 - Control Valve Terminals
To Optional
Remote
Accessory
9-Volt
Alkaline
Battery
Receiver
Terminal
Wires
Battery Clip
To Wall
Thermostat
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote
control unit (see Figure 40).
2. Attach terminal wires to battery. Place
battery into battery housing.
3. Replace battery cover onto remote control
unit.
Figure 40 - Installing Battery in Hand-
Held Remote Control Unit
9-Volt
Battery
Battery
Housing
Battery Cover
Terminal
Wires
Remote Control Unit
REMOvING/REpLACING GLASS
DOOR
CAUTION: Do not operate
this fireplace with a broken glass
door panel or without the glass
door panel securely in place. For
replacement part information see
Replacement Parts
, page 36.
CAUTION: Wear gloves and
safety glasses while handling or
removing broken glass. Do not re
-
move if glass is hot. Keep children
and pets away from glass.
WARNING: If fireplace has
been running, turn off and un
-
plug fireplace. Let cool before re
-
moving glass door or louvers.
Removing Louver Panels
Remove top and bottom louver panels by
simultaneously pulling both top end spring
latches towards center of appliance until
they are disengaged from locating holes
(see Figure 41). Repeat for bottom spring
latches and pull louvers outward. To install
or replace items removed, simply reverse
procedures above.
Figure 41 - Removing Louver Panel
Louver Panel
Spring Latch