![background image](http://html1.mh-extra.com/html/desa/tudor-cgdv32nr/tudor-cgdv32nr_owners-operation-and-installation-manual_2486215030.webp)
www.desatech.com
116646-01H
30
Figure 56 - Typical Flame Pattern
If you pilot assembly does not meet these
requirements:
• turn fireplace off (see
To Turn Off Gas to
Appliance
, page 27)
• see
Troubleshooting
, page 32
bURNER FLAME pATTERN
Burner flames will be steady, not lifting or float
-
ing. Flame patterns will be different from unit
to unit and will vary depending on installation
type and weather conditions.
If the vent configuration is installed incorrectly,
flames will lift or "ghost". This can be danger
-
ous. Inspect flames after installation to ensure
proper installation and performance.
INSpECTING bURNERS
Continued
Figure 56 shows a typical flame pattern.
If burner flame pattern differs from that de
-
scribed:
• turn fireplace off (see
To Turn Off Gas to
Appliance,
page 27)
• see
Troubleshooting
, page 32
ClEaNING aND MaINTENaNCE
WARNING: Turn off fireplace
and let cool before cleaning.
CAUTION: You must keep
control areas, burners and
circulating air passageways of
fireplace clean. Inspect these
areas of fireplace before each
use. Have fireplace inspected
yearly by a qualified service
person. Fireplace may need
more frequent cleaning due to
excessive lint from carpeting,
bedding material, pet hair, etc.
GLASS DOOR
WARNING: Handle glass
door panel with care. Do not
strike, slam or otherwise abuse
glass. Do not operate fireplace
with the glass door unlatched,
removed, cracked or broken.
WARNING: Do not use
abrasive cleaners as this may
damage glass. Use a nonabra
-
sive household glass cleaner to
clean glass. Do not clean glass
when hot.
Glass must be cleaned periodically. Dur
-
ing start up it is normal for condensation to
form on the inside of glass causing lint, dust
and other airborne particles to cling to glass
surface. During initial start up a slight film
may form on glass due to paint curing. Glass
should be cleaned several times with a non-
ammonia, nonabrasive household cleaner
and warm water after the first two weeks of
operation. Afterwards, clean glass two or three
times during each heating season, depend
-
ing on the usage and circumstances present.
Refer to
Removing/Replacing Glass Door
on
page 24 of this manual when removing glass
door for cleaning.
WARNING: Only parts sup
-
plied by the manufacturer should
be used when replacing broken
or damaged glass door panel
(see
Replacement Parts
, page
36). This glass door panel is
a complete unit. No substitute
materials may be used.