![background image](http://html1.mh-extra.com/html/desa/tudor-cgdv32nr/tudor-cgdv32nr_owners-operation-and-installation-manual_2486215024.webp)
www.desatech.com
116646-01H
24
Removing Glass Door
If replacement of glass is necessary, the
entire assembly, glass and frame, must be
replaced. If glass is broken, wear gloves and
tape remaining fragments onto frame.
1. Remove screen/rod assembly from fire
-
box, push rod either left or right and then
down and forward. Set assembly aside.
2. Lift up on latches to unlock. There are
two on top of firebox and two below
firebox that hold glass door in place (see
Figure 42).
3. While holding glass door to prevent it from
falling and causing injury, remove the five
screws from hinge located on left side of
door frame assembly (see Figure 42).
4. Remount new frame at hinge with five
new screws before closing door. This will
ensure seating of gasket.
5. Close glass door frame. Lock latches by
placing bar under tab on door and pushing
down and back on latch (see Figure 42).
6. Replace screen/rod assembly by revers
-
ing step 1.
7. Replace louvers by reversing procedure
under
Removing Louver Panels
, page 23.
FIREplaCE INSTallaTION
Continued
Figure 42 - Removing/Replacing Glass
Door
Lock
Unlock
Glass Frame
Assembly
Screw
Hinge
Latch
INSTALLING OPTIONAL BRICK
LINER MODEL BL32D
WARNING: If fireplace has
been running, turn off and un
-
plug fireplace. Let cool before
installing brick liner.
This brick liner kit is optional. You may pur
-
chase brick liner from your local retailer or
see page 37.
CAUTION: Always handle
brick panels with two hands.
Do not force brick panels into
place. Excessive force will break
brick panels.
1. Remove top and bottom louvers to allow
access to door latches.
2. Unlock door latches and open glass door.
See steps 1 and 2 of
Removing/Replacing
Glass Door
, page 23.
3. If installing brick liner in new fireplace,
go to step 4. If installing brick liner in an
existing fireplace, carefully remove logs,
lava rock and ember material.
4. Remove three screws from deflector
shield on the inside top of firebox. Set
shield and screws aside.
5. Install rear brick panel first. Rest bottom
edge of panel on back edge of grate (see
Figure 43).
6. Install left side brick panel by sliding it
between grate and side of firebox (see
Figure 43).
Figure 43 - Installing Rear Brick Panel
Rear Brick
Panel
Cleaning Glass Door
See
Cleaning and Maintenance
on page 31.