Derbi ATV DXR 200, Workshop Manual

Page: 46 / 194

45
3-28. B
ATTERY
R
EMOVAL
(F
IG
. 3-49)
When recharging or store, remove battery from ATV. The procedure;
01. be sure the ignition (main) switch is “OFF”
02. take out the seat
03. disconnect the negative (-) terminal lead from battery
04. disconnect the positive (+) terminal lead from battery
05. take out battery
06. store or re-charge battery
CAUTION
ONLY STORE THE BATTERY ON COOL AND DRY PLACE. DO NOT LEAVE OR STORE THE BATTERY IN HOT
(MORE THAN 30C) OR COLD (LESS THAN 0C) AREA.
3-29- F
USE
(15A) -- F
IG
. 3-49
To replace a fuse (15A), be sure to follow:
01. be sure the ignition (main) switch is “OFF”
02. open fuse holder and take out old fuse
03. install new fuse and close the fuse holder
CAUTION
BE SURE TO TURN THE IGNITION SWITCH OFF BEFORE CHECKING OR REPLACING THE FUSE TO PREVENT
ACCIDENTAL SHORT-CIRCUITING ON ELECTRICAL SYSTEM. IT A FUSE TAILS FREQUENTLY, WHICH MEANS A
SHORT- CIRCUIT OR AN OVERLOAD IN THE ELECTRICAL SYSTEM -- BE SURE TO CHECK. IT ON. ONLY USE
THE FUSE SPECIFIED AS (15A).
3-30. F
UEL
T
ANK
(F
IG
. 3-50, 3-51, 3 -52, 3-53, 3-54, 3-54A)
3-30-1. Fuel tank arid fuel valve removal
01. lock the fuel cap and fuel clock on “OFF” Fig. 3-50
02. loosen the screw Fig. 3-51
03. disconnect, the fuel horse Fig. 3-52
04. remove the fuel tank Fig. 3-54
05. remove the fuel valve
06. disassembly the fuel valve Fig. 3-54A
3-30-2. Fuel tank and fuel valve inspection
01. check valve strainer for dirt and clog -- clean or replace
02. check the o-rings for any wear/damage -- replace
03. check the rubber gasket for any wear/damage -- replace
04. check the fuel tank for any wear/damage
-- replace
05. check the fuel hose for any wear/damage -- replace
3-30 3. Fuel tanks and fuel valve installation
01. reverse the 3-30-1 procedure
02. check, for any fuel leakage
03. check the wire and horse connection