Deprag 330EG36-0012, Operating Instructions Manual

Page: 16 / 32

8 Description of the settings
Parameter Description
Torque unit The torque unit used for the display and setting of torque values.
Type of start The screwdriver can be started using push-to-start or button start.
This can be set via the menu Type of start (F05).
Delay interrupt Delay interrupt is set to prevent a screwdriving procedure being
recorded as cancelled if the start signal of the screwdriver is inter-
rupted and restarted within the set time. This is particularly impor-
tant in combination with a screw feeder to avoid errors when push-
ing the screw through the mouthpiece.
Torque mode There are two torque modes available for the screwdriver:
Torque setting in torque unit steps:
In this mode only program 1 is active as the screw assembly pro-
gram as well as program 6 as the loosening program. All parame-
ters (which had been adjusted in the menu) are used from program
1.
The shut-off torque for program 1 can be adjusted directly using the
program selection button.
The reversal button is used to start loosening program 6.
Select between adjustable screw assembly and loosening pro-
grams:
In this mode there are 5 screw assembly and 5 loosening programs
available which can be adjusted via the menu.
Use program selection to select between the programs 1 to 5.
Use the reversal to start the corresponding loosening program (e.g.
screw assembly program 2 -> Loosening program 7).
Password The screwdriver menu can be protected using a password. The
password can be set in the range 000 to 999.
If the password is set to 000 all menus are freely accessible.
It is set to 000 on delivery.
Main rotational di-
rection The main rotational direction shows which direction is defined as
screw assembly. Main rotational direction right means that all
screwdriving templates for screw assembly are in right rotation and
all screwdriving templates for loosening are in left rotation
Tables 5: Description of the settings
16