Periodic inspection and maintenance
GAW-185ES2
- 32 -
(2) Check of fuel level
CAUTION
: Fire
▪
Fuel and oil are combustible materials. Never bring any fire close to
the welder. Do not use the welder in a place where the welder
exposed to sparks of welding or of a sander. Do not perform fueling
while you are smoking or while the welder is running.
▪
If the fuel or oil has spilt, fully wipe it off.
Ignition or kindling may occur, a fire may arise and burn injury
may result, if you fail to observe the precautions given above.
Check, by observing the Fuel gauge.
If the fuel is low, fill the fuel tank with clean and fresh NON-LEAD gasoline. Do not over fill the fuel tank.
The fuel tank cap must be closed tightly after filling.
If the fuel is contaminated, close the fuel cock and drain to the receiver pan from the cup / tank.
Regarding fuel
(a) Use NON-LEAD gasoline. Do not use any alternative fuel
because its quality is not known, it exerts adverse effect over the
engine.
(b) Do not over fill red marking at fuel filler port filter.
[Caution]
: If the fuel or oil has spilt, fully wipe it off.
Be cautious of the fuel!!
▪
Never fill the fuel tank while the engine is running or in the dark. Gasoline soillage on a hot engine
can cause a fire or an explosion. If gasoline spillage occurs, wipe up the spilled gasoline completely
to prevent hazards.
