Dentsply Maillefer X-SMART PLUS EM09M, User Manual

Page: 38 / 209

FISDR-JAP / F1902124.X / 00 / 2011 – created 07/2011
- 39 / 208 -
9. Troubleshooting
When trouble is found, check the following points before contacting your distributor. If none of
these are applicable or the trouble is not remedied even after action has been taken, the
product may have failed. Contact your distributor.
X-SMART ™ Plus control unit and AC adapter
Problem Cause Solution
The power is not turned
on. The AC adapter is not connected. Check the connection.
The plug of the AC adapter is not
inserted into the outlet, or there is no
electricity in the outlet. Check the connection.
The battery is flat. Charge the battery or use the AC
adapter.
No battery is inserted. Insert battery, or use the AC adapter.
The internal fuse has burnt. Contact your distributor.
AC-IN lamp does not light. The AC adapter is not connected. Check the connection.
The plug of the AC adapter is not
inserted into the outlet, or there is no
electricity in the outlet. Check the connection.
The internal fuse has burnt. Contact your distributor.
The AC adapter fuse has burnt. Contact your distributor.
The AC adapter does not
work.The CHRG lamp
does not light. No battery is inserted. Insert battery.
The battery is fully charged or in a
state near full charge. No problem.
The temperature of the battery is
low. If the temperature of the battery is less
than 0°C (32°F), the battery is not
rechargeable. Charge the battery in a
warm room. Be careful about moisture
condensation.
The temperature of the battery is
high. It is normal that the battery temperature
is slightly elevated right after charging.
If the battery is hot during normal
operating conditions, it may indicate an
abnormality. Contact your distributor.
An error code is displayed. See chapter 8.