DentalEZ Core, User Manual, Page: 28 / 57

25
www.DentalEZ.com 866-DTE-INFO
25
DentalEZ
®
Equipment
PN: 2717-267C
Tools Required
• 1/8" Hex Key
1. Select the following hardware package items
(Figure 25) :
• 1/4" × 3/4" Set Screw
• 1/4" × 3/8" Set Screw
• 3/8-16" × 2¼" Hex Head Bolt
• 3/8" Flat Washer
• 3/8" Lock Washer
• Four Thrust Washers
• Two Thrust Bearings
• Pivot Cover
• Post Pivot Pin
• Post Stop
2. Raise the chair base to its upper travel limit
and disconnect the chair power.
3. Apply lubricant to both sides of all thrust
washers and thrust bearings.
4. Place a thrust washer, bearing and another
thrust washer onto the pivot pin. Then insert
Light or Monitor Post (Optional)
the pivot pin and bearing stack through the
1-1/4" brass bushing at the end of the light/
monitor post. Place another thrust washer,
bearing and thrust washer onto the pin.
5. While holding the bearings and pin in the post,
align the machined hole in the pivot pin with
the pin in the chair support’s bottom counter
bore. Then adjust the unit post and pin so the
pin will slide into the counter bore.
NOTE: Engagement is a slip fi t, provided the
Magellan light/monitor post is held in alignment.
Section III Installation
Figure 25. Light/monitor post hardware
Post Stop
1¼" Brass Bushing
3/8" Lock
Washer
3/8" Flat Washer Post Pivot Pin
Slot
Thrust
Washers
Counter Bore
1/4" × 3/4"
Set Screw
3/8"-16 × 2¼"
Hex Head Bolt
Light Arm or
Monitor Arm
1/4" × 3/8"
Set Screw
Pivot Cover
Thrust Bearing
Thrust
Washers
Thrust
Bearing
Light
Post