22
7.1.3 Verification result output
(1) Report of match/mismatch status
You can select any of the following report types using the configuration software (ScannerSetting_2D). Selecting
"Disable transmission" reports nothing.
Setting
If there is a match:
If there is a mismatch:
1
Disable transmission.
Disable transmission.
2
Enable code data transmission.
Enable code data transmission.
3
Enable OK transmission.
Enable NG transmission.
(2) Beeper and indicator LED
You can check whether the verification result is a match or mismatch with the beeper and indicator LED.
When the beeper and indicator LED are enabled, they act as shown below.
Beeper Indicator
LED
If there is a match:
Emits a short beep.
Lights in blue.
If there is a mismatch: Emits a long beep.
Lights in red.
Output of the master data registered
Scanning the "Output master data" code given below lets the scanner output the verification section of master data
entered in the data verification read procedure, together with the code ID mark.
"Output master data" code
