Denon AVR-X500, Owner'S Manual

Page: 62 / 66

59
G
Audio
H
Symptom Cause/Solution Page
Audio is not output. • Check the connections for all devices.
• Check the speaker connections and configurations.
• Check whether the audio device power is turned on.
• Adjust the master volume.
• Cancel the mute mode.
• Select a suitable input source.
• Select a suitable input mode.
• Disconnect the headphones. No sound is output from the
speakers when headphones are connected.
6 , 7 , 10 , 11 ,
12 , 13
28
–
16
16
15
35
47
The volume does not
increase.
• The maximum volume is set too low. Set the maximum volume
using “Limit” on the menu.
• Power for external devices connected to the output connectors
of the unit may not be turned on. Check the power of connected
external devices.
39
–
No sound is
produced from
surround speakers.
• Check if the surround speakers are connected to the SURROUND
terminals.
–
No sound is
produced from
subwoofer.
• Check the subwoofer connections.
• Turn on the subwoofer’s power.
• Set “Speaker Config.” – “Subwoofer” on the menu to “Yes”.
• If “Front” and “Center” for “Speaker Config.” are set to “Large”,
and “SW Mode” is set to “LFE”, no sound may be output from
the subwoofers, depending on the input signal or selected
surround mode.
27
–
37
37
DTS sound is not
output.
• Set “Decode Mode” on the menu to “Auto” or “DTS”. 35
Dolby TrueHD, DTS-
HD, Dolby Digital
Plus audio is not
output.
• Make HDMI connections. 6
Dolby PL g mode or
DTS NEO:6 mode
cannot be selected.
• Check that “Speaker Config.” – “Center” or “Surround” is set
to other than “None”. If the speaker system is 2.0/2.1ch, this
surround mode cannot be selected.
• When headphones are used, Dolby PL g or DTS NEO:6 cannot be
selected.
37
–
RESTORER cannot
be selected.
• Check that an analog signal or PCM signal (fs=44.1/48 kHz) is
input. For playback of multi-channel signals such as Dolby Digital
or DTS surround, RESTORER cannot be used.
44
G
Radio
H
Symptom Cause/Solution Page
Reception fails, or
there is a lot of noise
or distortion.
• Change the antenna orientation or position.
• Separate the AM loop antenna from the unit.
• Use an FM outdoor antenna.
• Separate the antenna from other connection cables.
13
13
13
13
G
Remote Control Unit
H
Symptom Cause/Solution Page
The set cannot be
operated with the
remote control unit.
• Batteries are worn out. Replace with new batteries.
• Operate the remote control unit within a distance of about 7 m
from this unit and at an angle of within 30°.
• Remove any obstacle between this unit and the remote control
unit.
• Insert the batteries in the proper direction, checking the
q
and
w
marks.
• The set’s remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
51
51
51
51
51
Basic instr
uctions
A
dv
anced instr
uctions
Inf
or
mation
Inf
or
mation
DVD