Denon AVR-1712, Service Manual

Page: 16 / 161

16
SPECIAL MODE
Special mode setting button
b
No.1 - 10, 12 : Press the ON/STANDBY button to turn on the power while pressing both the button A and the button B at the same
time.
b
No.11 : Turn on the power, then press and hold down the A and B buttons for over 3 seconds.
No. Mode Button A Button B Contents
1
Version display
(μcom/DSP Error Display)
DIMMER
STATUS
Firmware versions such as Main or DSP are displayed in the FL
manager. Errors are displayed when they occur. (Refer to 17 page)
2 Displaying the protection history mode
STATUS SLEEP
The protection history is displayed.
(Refer to 19 page)
3
User Initialization mode
(Installer Setup settings are not initialized.) DOCK
CONTROL
8
DOCK
CONTROL
9
Backup data initialization is carried out.
(Installer Setup settings are not initialized.)
4
Factory Initialization mode
(Installer Setup settings are also
initialized.)
DOCK
CONTROL
2
DOCK
CONTROL
8
Backup data initialization is carried out.
(Installer Setup settings are also initialized.)
5
Mode for switching tuner frequency step
(E2 model Only)
- -
Change tuner frequency step to FM:200kHz/AM:10kHzSTEP
6
Mode for preventing remote control
acceptance DOCK
CONTROL
2
DOCK
CONTROL
iPod
1
Operations using the remote control are rejected.
(Mode cancellation: Turn off the power and execute the same
button operations as when performing setup.)
7 Panel lock mode
DOCK
CONTROL
8
TUNER
PRESET CH +
Operations using the main unit panel buttons or the master volume
knob are rejected.
8
Panel lock mode
(Master volume is not locked.) DOCK
CONTROL
8
SLEEP Operations using the main unit panel buttons are rejected.
9 Cancellation of panel lock mode
DOCK
CONTROL
8
SAT/CBL
Panel lock mode is cancelled.
10 Diagnostic mode
DOCK
CONTROL
2
STATUS
This mode is used for confirming the Video and Audio (signal)
paths. (Troubleshooting)
The signal paths of the set can be easily confirmed after repair.
11 Remote ID Setup mode
DOCK
CONTROL
2
STATUS
When using multiple DENON AV receivers in the same room, make
this setting so that only the desired AV receiver operates.(Refer to 21
page)
NOTE:
If " REC " is displayed on the fluorescent display, the set is in the special developer's mode and the RS-232C
communications are not possible.
Turn on the power, then press and hold down the "DOCK CONTROL
8
" and " STATUS " buttons for over 3 seconds to
turn off "REC" on the display. RS-232C communications are now enabled.
DIMMER
SLEEP STATUS
TUNER PRESET
CH +
DOCK CONTROL
iPod
1
ON/STANDBY SAT/CBL
DOCK CONTROL 2
DOCK CONTROL 9
DOCK CONTROL
8