ENGLISH
36
Advanced Operation
Advanced Operation
ENGLISH
5
When the input source is set to TUNER, the
preset channel can be selected pressing the
CHANNEL
button on the remote control unit.
•
The input source selected with the
INPUT SELECTOR
knob is
output for the ZONE2 speaker output.
Initialization of the microprocessor
If the indication on the display is not normal or if the operation of
the unit is not correct, then the microprocessor should be reset
by the following procedure.
1
Switch off the unit using the main unit’s
POWER
switch.
2
Keep both
SPEAKER A
and
B
buttons depressed
and turn on the unit by pressing the main unit’s
POWER
switch.
3
Check that the entire display is flashing at 1-
second intervals and release the buttons.
• The microprocessor will be initialized.
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from
the factory).
Other functions
Last function memory
• This unit is equipped with a last function memory which stores
the input and output setting conditions as they were
immediately before the power is switched off.
This function eliminates the need to perform complicated
resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function
provides approximately one week of memory storage when the
main unit’s
POWER
switch is off and the power supply cord
disconnected.
POWER
SPEAKER
INPUT SELECTOR
Recording the program source (recording the
source currently being monitored)
1
Select the input source to be played.
3
Start recording on the tape or video deck.
For instructions, refer to the component’s operating instructions.
2
Select the input mode and play (surround) mode.
• The AUDIO IN’s signal selected with the
INPUT SELECTOR
knob
are output to the CDR/TAPE and VCR AUDIO OUT terminals.
2
Simultaneous recording
The signals of the source selected with the
INPUT SELECTOR
knob
are output simultaneously to the CDR/TAPE and VCR REC OUT
terminals. If a total of two tape and/or video decks are connected
and set to the recording mode, the same source can be recorded
simultaneously on every decks.
