ENGLISH
Basic Operation
Basic Operation
ENGLISH
19
Press the
VIDEO SELECT
button repeatedly until the
desired source appears on the display.
Combining the currently playing sound with
the desired image (VIDEO SELECT)
Use this switch to monitor a video source other than the
audio source.
IN=V SOURCE
• Canceling simulcast playback:
q
Select “SOURCE” by pressing the
VIDEO SELECT
button.
w
Switch the program source to the component connected to
the video input terminals.
Press the
SPEAKER A
or
B
button to turn the
corresponding speaker pair on.
The front speaker A, B setting can be also be changed with
the
SPEAKER
button on the remote control unit.
Selecting the front speakers
Connect the headphones to the
PHONES
jack.
• The speaker output is automatically turned off when headphones
are connected.
NOTE:
• To prevent hearing loss, do not raise the volume level
excessively when using headphones.
Listening over headphones
Checking the currently playing program
source
2
Front panel display
Press the
STATUS
button.
Descriptions of the unit’s operations are also displayed on
the front panel display. In addition, the display can be
switched to check the unit’s operating status while playing
a source.
2
Using the dimmer function
Press the
DIMMER
button.
The display brightness changes in four steps (bright, medium,
dim and off).
AUTO
(auto mode)
:
In this mode, the types of signals being input to the digital and
analog input terminals for the selected input source are
detected and the program in the AVR-1506’s surround
decoder is selected automatically upon playback. This mode
can be selected for all input sources other than TUNER.
The presence or absence of digital signals is detected, the
signals input to the digital input terminals are identified and
decoding and playback are performed automatically with the
DTS, Dolby Digital or PCM (2 channel stereo) format. If no
digital signal is being input, the analog input terminals are
selected.
Use this mode to play Dolby Digital signals.
DTS
(exclusive DTS signal playback mode)
:
Decoding and playback are only performed when DTS signals
are being input.
PCM
(exclusive PCM signal playback mode)
:
Decoding and playback are only performed when PCM signals
are being input.
Note that noise may be generated when using this mode to
play signals other than PCM signals.
AUTO
PCM
DTS
Press the
INPUT MODE
button.
The mode switches as shown below each time the
INPUT
MODE
button is pressed:
Input mode
The AVR-1506 has an AUTO signal detection mode that
automatically identifies the type of incoming audio signals, but is
also equipped with a manual mode that can be switched
according to the type of input audio signals.
2
Selecting the AUTO, PCM and DTS modes
PHONES
VIDEO SELECT
DIRECT/STEREO
MASTER VOLUME
STATUS
DIMMER
SPEAKER
ANALOG
INPUT MODE
SPEAKER
DIMMER
ANALOG
INPUT MODE
VIDEO SELECT
STATUS
DIRECT
STEREO
