bio.x T700 160416
Page 9 of 16
10/2008
Energy-saving mode
The unit can be switched to energy-saving mode during downtimes such as night-time, weekends, or company
holidays. To do so, the multi-function button is pressed for 3 seconds. "30" will be shown on the display. The
temperature is maintained at 30º C in energy-saving mode. The micro-organisms remain active at this
temperature and optimum oil and grease degradation is guaranteed.
You can switch from energy-saving mode by just pressing the button again and the unit will heat the detergent to
41º C again. The warm-up stage takes about an hour, depending on the ambient temperature. Once this
temperature is reached and "41" is shown continuously on the display, the unit is ready for operation with optimum
cleaning assured.
8. Maintenance
Warning!
Before starting work on the cleaning table fixtures, switch off the electrics and unplug from
the mains! Test the equipment to ensure the power is off!
8.1 Filter
The washstand is equipped with two filters as standard. A stainless steel perforated filter on the washstand surface
and a synthetic filter for impurities underneath. It is recommended to clean these filters on a
daily
basis. To do so,
remove the filters from the unit and rinse with water.
For maintenance purposes the work surface can be lifted
inside the tank and lent against the back wall of the upper
part.
.
8.2 Fill level
Check the fill level against the markings on the tank wall regularly
so you can refill to make up for any losses through evaporation
and removal. If the fill level falls under a minimum of 60 litres
(lowest marker line), the pump and the heating system switch off
automatically for safety reasons. In such a case, "LO" is shown on the display. Re-fill the detergent until the top
marker line is reached. The message will disappear once there is enough detergent in the tank.
8.3Additive
More additive should be put in every 6 months to replenish the micro-organisms.
After refilling, the detergent must be left to stand for 24 hours so that the micro-organisms can become
active. It is therefore recommended to refill with the additive before a weekend.
8.4Suction filter (6)
In order to prevent the pump from losing pressure, the suction filter inside the tank should be cleaned at regular
intervals. For this purpose the suction filter can be moved to an elevated position and with the help of the cleaning
nozzle (set to surface jet) freed from deposits.
If the suction filter is so dirty that it can no longer be cleaned in this way, it has to be replaced.
Perforated filter
