bio.x T700 160416
Page 4 of 16
10/2008
1. General Instructions
This user manual is for the bio.x parts cleaning unit T700. It contains all the information needed regarding correct
startup, trouble-free operation, maintenance, removal from service and disposal. The information and
instructions in this user manual have to be observed and adhered to.
If the instructions are strictly followed in accordance with the user manual, we accept liability within the scope of
our conditions for guarantees.
Without approval from the manufacturer no changes, extensions or modifications may be made to the
product. For changes made without approval from the manufacturer no liability is assumed and the
guarantee expires.
National regulations and safety regulations have to be adhered to.
2. Safety instructions
This unit can only be used safely if you read this user manual carefully and strictly follow the instructions it
contains. This user manual is an integral part of this unit and must be available to the personnel who
operate the unit at all times.
Such staff must be familiarised with the user manual with particular attention being paid to prohibitions and
hazard warnings.
The mains supply connection has to be in accordance with the corresponding regulations (VDE 01000 -
Association of German Electricians). For safety reasons the equipment must be only operated, if a Residual
Current protective Device (RCD) with a release current of 30 mA is connected upstream.
This must be checked by a qualified electrician.
In accordance with the German BGV A3 electrical equipment has to be examined in regular intervals.
The equipment must be set up on a suitable stable, level surface.
Detergents which contain highly flammable substances must not be used. Use only detergents approved by
DENIOS for this unit.
3. Technical data
Dimensions (WxDxH)
1100 mm x 910 mm x 1725 mm
Total height with open hood
2400 mm
Net weight
approx. 80 kg
Power consumption
1.1 kW (when heating turned on)
Electrical connection
1/N/PE 230V
∼
Pre-fusing on site
min10 A
Work surface height
950 mm
Load capacity
200 kg
Tank LDPE
Maximum fill capacity
120l
Minimum fill capacity
60l
Usable work surface
750-900 mm x 550 mm
Heater
Stainless steel (1.4541) heating element output 1 kW
Level switch
Minimum fill level (approx. 55l l)
Temperature sensor
Set at 41°C in the factory
Pump
approx. 240l/h
approx. 6 bar
For the operation of the demister a compressed air supply is essential:
-
Input pressure
6-8,5 bar
-
Output 350
l/min
