bio.x T700 160416
Page 8 of 16
10/2008
6. Bedienfeld
6.1 Function indicators on the display.
Function Indicator
Warming-up process
Display ’41’ flashing, LED heater on
Rising horizontal bars
Operating temperature reached,
heater off
Display ’41’ flashing, LED heater off
Operating temperature reached,
heater on
Display ’41’ flashing, LED heater on
Excess temperature
Temperature indicator flashing
when T>41°C
Energy-saving mode
Display ‚30’
Fault messages,
see section 6.2 (fault messages)
Display ‚LO’; F1 bis F8
7. Operation
-
When cleaning the hood should be closed
-
If you are working with a brush, you may also clean with the hood open.
-
Place the parts to be cleaned in the Parts Cleaning Unit.
-
Do not exceed the maximum load of 200 kg!
-
Connect the Vario nozzle or the cleaning brush with the high-speed coupling to the cleaning hose.
-
Close the cover.
-
If necessary turn on the light with the on/off switch (9).
-
Reach for the cleaning equipment through the gauntlets. Depending on the type of dirt the Vario nozzle can be
adjusted from point to surface jet and by moving forward or back to low density.
-
By pressing the foot switch you turn on the feed pump and the demister and you can start cleaning.
-
After you have finished cleaning press the foot switch again to turn off the demister and the feed pump. The
demister is turned off after a time delay of 30 seconds. The water pump automatically switches off after about 60
minutes.
-
The Parts Cleaning Unit can also be switched on and off by pressing the multi-control button on the control panel.
-
Take out the cleaned parts.
Multi-control button
Display
LED heater
