TT-2000 OPERATING PROCEDURE3
REVS.
25T
Rev. 3.1
K
Two switches (red and
are located inside the unit. These switches
are
the left side of the lower shelf near the mechanism. The
switch
is wired to the
switch. These switches are used in the procedures below to
do an audit, and to set the date, time, options, values, and ticket point values for
new bar codes, and other functions
Printers:
Dot Matrix:- Star Only
Two small switches are mounted to a small PC Board next to the printer
is mounted to the door. There are also three
mounted on the
same board. The top LED is just an 'ON' indicator.
LED is green.
The bottom LED is the 'ON LINE' indicator (also green) and will normally
on when the unit is turned on.
top switch will turn this LED
alternately on then off if pressed. The other switch will cause the printer
to feed paper. The middle LED (red) will only turn on when the printer
has a problem (such as out of paper).
Thermal:-Citizen Only
There is
small push button switch on the side of printer. Tlus switch
advances the paper through printer. There is a toggle switch next to it. Tlus
is the power switch. Please refer to page 7 in this manual for paper
loading. Refer to PPU-231
manual for printer care and various
functions.
of Date, Time, and Bar-coded Tickets
I.
Open top door of TT-2000. Pull "Main Safety" switch out. Display will
cycle through test mode. When display returns to "Snake Mode", Push swl
on logic PCB. Display will read 99-0. You are now in "SETUP MODE".
The red "Internal Power" switch must be on.
