entire shelf area clean of dust. Optos
be affected the
dust build-up. Note: While cleaning unit, TURN POWER
OFF. Do not use a
vacuum to clean any PCB's. A can of
air will do the job (or compressor).
Do not bloclr exhaust fan on rear and right side of unit. If placing
near
any other
allow
in.
it.
10.
trash
display reads "FULL" press either re-set
switch. If bin is
erratically the
will be
If trash
disposal is scheduled otherwise,
Shift changes etc. Counter
be
re-set at any time.
or Version2 Revl-2. NOTE:
bin will re-set anytime either re-set switch is pressed. No audit will print.
1
1.
"Paper low" indication is set to specific paper roll lengths.
display reads
replace with new roll
in program
set
display to read 99-5 press both switches to re-set, close door
power
12.
Printer
are indicated by display reading
A.
Paper
in printer (Not exit plate).
B.
Printer goes off line.
C.
Loss of power.
D.
Data not being received.
Incorrect loading of paper- out of paper
Note:
printer experiences power loss or goes off line, unit must be
powered down
up.
no
indicates ticltets in guide or in
block.
A.
entrance bloclr. Display will
show
count, re-insert ticltets.
B.
power off to
assembly.
TURN
LARGE
GEAR IN REVERSE. Ticltets will appear at entrance.
C.
If necessary, remove Barcode PCB
Guide
(see important
instructions for guide assy.
PG 15).
ticltets, replace PCB
Assy.
Page 1
