NOTE:
For
Rev.4 OP2
=
Position
=
Position
For BCR-1000 Rev.3
Use Position 1 or 2
For Ticket guide assemblies with
OVAL cutouts use Position 1 or
2.
For Ticket guide assemblies with
ROUND cutouts use: Position 1 ONLY.
(Middle Sensors Only)
IMPORTANT: For Sensor Replacement:
Scanner PCB's BCR-1000 Rev.
2
3
and HO-1000 Rev. 4, have sensor
bracket mounting holes marked
"A" (Marked on drawing only)
Use only when replacing middle or rear sensors.
Other sensors use PCB mounted "studs" to brace sensors.
replacing sensors, note Rev.# on PCB. If mounting holes do not
exist, remove brackets before mounting.
(Insert sensors to same depth
and direction
as all others).
SENSOR PLACEMENT: Each scanner PCB has specific sensors in certain locations.
For HO-1000- All Revs. USE:
shaped Lens) OP4 and
(can be used in
(Flat Lens)
and OP2-3
O
N
L
Y
For
A11 Revs. USE:
("V" shaped Lens)
and
(Flat Lens) Can be used in OP2 ONLY
NOTE: For BCR-1000 PCB, All Revs.
is
ONLY
