Position one MonkeyMESH Bracket at the top left boundary of where you
want the MonkeyMESH Panel to cover. This MonkeyMESH Bracket must
have the mounting flange facing outwards from where the MonkeyMESH
Panel will be.
Position another MonkeyMESH Bracket at the top right boundary of
where you want the MonkeyMESH Panel to cover. This MonkeyMESH
Bracket must also have the mounting flange facing outwards from where
the MonkeyMESH Panel will be.
Check that both “top” MonkeyMESH Brackets are at the same height and
that both MonkeyMESH Brackets are “the same way up.” Tighten the
fixings on both MonkeyMESH Brackets (maximum torque is 22Nm).
Position the MonkeyMESH Panel so that one of the top three horizontal
wires slots in to and then “hangs down” in the top catchment slot. Make
sure that the panel has the stiffening wires are on the “inside” of the
racking assembly.
Both the left MonkeyMESH Bracket and the right MonkeyMESH
Bracket’s top catchment slots should have the same horizontal wire in
them.
The MonkeyMESH Panel should be able to hang from these two
MonkeyMESH Brackets while installation continues.
1
2
3
4
5
6
1
2
3
4
5
6
Step 1
Position & Fix “Top Brackets”
Step 2
Position MonkeyMESH Panel in “Top Brackets”
Introduction
Assembly and Installation
Preparation
Inspection
MonkeyMESH Manual
P10
RACKMAN AUSTRALIA
AUTHORISED DISTRIBUTOR
1300 722 626
www.rackmanaustralia.com.au
