This section describes the correct way to assemble MonkeyMESH. By following these instructions
you will achieve the highest Return On Investment from your wire backing system and contribute to a
safe workplace.
Before assembly or use of MonkeyMESH, the specifier must ensure that the product supplied
is correct and appropriate to your workplace. You should also check
deltashelving.com
to ensure
that you have the current version of this MonkeyMESH Manual.
For the purposes of the product warranty and to ensure both the safety and integrity of your
workplace, MonkeyMESH must be installed, used and maintained as detailed in this manual.
If the product you are attempting to install does not match the description or requirements of this
manual or the site specifics are not compatible with the product, do no install the MonkeyMESH wire
backing system. Contact Delta immediately to assist in resolving the issue.
Assembling MonkeyMESH
MonkeyMESH Manual
P6
The following tools are required for installation:
Ratchet and socket extension to suit M8 screws and nuts
An M8 spanner
Additionally, we recommend the use of the following Personal Protective Equipment (PPE):
Planning Your Installation
Safety Glasses
Steel-Capped Boots
High-vis Work Wear
Throughout the development of MonkeyMESH we have investigated and tested the safest and most
efficient method of installation.
Installation should start at one end of the racking assembly, commencing at the top-most position
for a MonkeyMESH Panel. The next section to be installed should be the section immediately
underneath,and so on until you reach the bottom of that rack.
The installer should then move to the section of the racking assembly immediately next to the section
that now has MonkeyMESH installed, and again start from the top and work down. The following
diagram illustrates our recommendation for the order in which MonkeyMESH Panels should be
installed:
1
2
3
4
5
6
7
8
9
10
11
12
Please note
Before beginning
installation, make sure
to carefully measure
where the MonkeyMESH
will go on the racking
assembly. If you install
the top Bracket too low,
the bottom Bracket may
not have enough space
to be installed.
!
Preparation
Introduction
Assembly and Installation
Inspection
RACKMAN AUSTRALIA
AUTHORISED DISTRIBUTOR
1300 722 626
www.rackmanaustralia.com.au
