Position one MonkeyMESH Bracket at the bottom left boundary of where
the MonkeyMESH Panel covers. This MonkeyMESH Bracket must have
the mounting flange facing outwards from the MonkeyMESH Panel.
Hold in place with fixings, but do not fully tighten.
Position another MonkeyMESH Bracket at the bottom right boundary of
where the MonkeyMESH Panel covers. This MonkeyMESH Bracket must
also have the mounting flange facing outwards from the MonkeyMESH
Panel.
Hold in place with fixings, but do not fully tighten.
Check that both MonkeyMESH Brackets are at the same height and that
both MonkeyMESH Brackets are “the same way up”.
1
3
4
5
6
Step 3
Position the “Bottom Brackets”
2
5
6
Step 4
Position MonkeyMESH Panel in “Bottom Brackets”
1
2
3
4
Position the MonkeyMESH Panel so that one of the bottom three
horizontal wires slots in to the bottom catchment slot.
Both the bottom left MonkeyMESH Bracket and the bottom right
MonkeyMESH Bracket’s bottom catchment slots should have the same
horizontal wire in them.
Introduction
Assembly and Installation
Preparation
Inspection
MonkeyMESH Manual
P11
RACKMAN AUSTRALIA
AUTHORISED DISTRIBUTOR
1300 722 626
www.rackmanaustralia.com.au
