Repeat Steps 1 – 5 as required for the remaining sections of
MonkeyMESH to be installed.
Refer to the Preparation section for information on the recommended
order for installation of your MonkeyMESH Kits.
Step 6
Repeat as Required
1
3
4
5
6
2
Manually push the “bottom” MonkeyMESH Brackets downwards so that
the MonkeyMESH Panel’s horizontal wires push up into the top part of the
MonkeyMESH Brackets’ catchment slots. The maximum force that should
be used when pushing down is 15kg.
The tension created by pushing down on the bottom MonkeyMESH
Brackets once the mesh is in place creates a positive lock and adds
greater rigidity and strength throughout the MonkeyMESH Panel.
Creating this tension is a key requirement of the MonkeyMESH system.
Unless this positive lock is created through the application of tension, the
wire backing system may not perform to specification.
While pressing down to create the tension, tighten the fixings on both
MonkeyMESH Brackets (maximum torque is 22Nm).
1
2
3
4
5
6
Step 5
Push Down and Fix “Bottom Brackets”
Introduction
Assembly and Installation
Preparation
Inspection
MonkeyMESH Manual
P12
RACKMAN AUSTRALIA
AUTHORISED DISTRIBUTOR
1300 722 626
www.rackmanaustralia.com.au
