８
. Do not install the Product in following types of locations:
a) A location with severe fluctuation of temperature.
b) A location that is exposed to sea breeze (excluding the Wireless Communication Unit for Inverter).
c)
A location that is exposed to volatile, combustible, corroding or toxic gases.
d) A location exposed to direct sun light.
e) A location exceeding the operating temperature range (-20 to +50°C) (5 to 35°C for the USB
Wireless Module).
f
) A location with altitude of 2,000 meters or higher.
g) A location with a large amount of dust (powder dust, sand dust, cotton dust, metal dust,
saw dust, straw dust and the like).
h) A location covered by metals or metal fittings, metals installed on walls, on top of a metal desk,
between metal products or near telephone unit, facsimile unit, personal computer, personal
computer peripheral device, television set, microwave oven or induction heating (IH) product.
９
.
Store the Product in a location with the temperature ranging between -20 and +60°C, with the
humidity ranging from 30 to 85% RH.
10. The Product communicates wirelessly.
Install the Product as far away as possible from devices that emit strong radio waves, such as a
civil band radio equipment.
11. The communication performance varies depending on the peripheral environment. Verify in
advance that the Product is communicating normally when installing the Power Monitor on a wall.
12.
Avoid installing the Power Monitor near iron plate or steel reinforcements and try to install the
Product with as much clear space as possible.
13. The Product is not compatible with the Total Amount Purchasing System of the Feed-in Tariff
Scheme for Reusable Energy.
14. Do not pull out the USB Wireless Module while the power is turned on. Communication with the
personal computer and the Meter will no longer be possible.
15.
Turn OFF the power breaker for the solar power generation on the power distribution board,
remove the AC adapter of the Power Monitor from the power outlet, and contact the retailer where
the Product was purchased when any instance of radio frequency interference occurs with the Product.
16. Do not use any USB Wireless Module other than the one that was bundled with the Product.
１
. The value displayed as power consumption may be greater than (or smaller than) the actual value
when the power being generated fluctuates due to fluctuation of sun light or the like. This arises
from the difference in the timing of data acquisition for the power production from the power feed-in
and purchase and is not due to a malfunction of the Product.
２
. The amount of power purchased displayed on the Home screen or Log screen may differ from
the power amount indicated on statements from the power company, due to such causes of errors
as those described below:
(1) Errors in measurement: The error arising from the fact that the instrument used by the power
company for the purpose of calculating the amount of power purchased is not a specified
measuring instrument but instead it is another equipment.
(2)
Errors in calculation: The error arising from rounding up or rounding off of figures in the
calculation and display process of the Power Monitor.
Equipment Specification Considerations
8
Introduction
