Page 9
4°
WEDGE BOL
T
SIDE BOLT
STEM ANGLE ADJUSTMENT
The stem can be adjusted to raise the height of the handlebar to suit the desired riding
position.
1. Loosen but do not remove the wedge bolt located on the underside of the stem.
2. If necessary, loosen the bolts on the side of the stem.
3. Adjust the stem to the desired angle.
4. Tighten the bolts on the side of the stem to 8 Nm if they were loosened in step 2.
5.
Tighten the wedge bolt on the underside of the stem to 14-15 Nm.
If you choose to change the angle of the stem it is likely you will need to adjust the angle
of the handlebars. Repeat the steps in the section “Handlebar adjustment” above to get
the correct angle for the handlebar if necessary.
WARNINGS
•
Insufficiently tightened bolts that controls the stem angle may compromise steering
action, which could cause you to lose control and fall leading to serious injury or
death. Ensure there is no movement by pulling up and pushing down on the stem,
properly torque bolts to the specified Nm.
Summary of Contents for BR1000
Page 1: ...Page 1 USER MANUAL rDrive 31 01 2022 ...
Page 35: ...Page 35 ...
