7
ASSEMBLY
B
C
D
Fig. 1
A
E
A
B
Fig. 2
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
ASSEMBLY TOOLS REQUIRED
Chuck Key/Wrench (Supplied)
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes less than 30 minutes.
HOW TO RAISE AND LOWER THE HANDLE
1. Attach the hub of the handle assembly (A) Fig. 1 to the end of the pinion shaft (B). Fasten the handle to the pinion
shaft using the special screw (C) and spring (D).
2. Raise the mortising machine head (E) Fig. 2 to the “up” position by turning the handle (A) clockwise.
NOTE:
The handle (A) is spring-loaded. Reposition it by pulling it out and moving it on pinion shaft (B).
B
C
A
Fig. 3
Fig. 4
D
B
ATTACHING THE HYDRAULIC CYLINDER
Place the head (A) Fig. 3 in the “up” position. Attach the hydraulic cylinder (B) to the two fittings, one located on the
back of the head (C) Fig. 3, and the other on the column (D) Fig. 4. Push each end of the hydraulic cylinder on its fitting
to secure the cylinder.
